August 2013 BOSCH-21Prices Ex. GST
Capacitive touch
buttons
Mechanical
PTT button
Paper label
inserts
Powered over CAT5 cable
from PLM-8M8
CAT5
Cable
Power switch
and connector
Amplifier
channel outputs
Ethernet
control port
Channel
attenuation
Active override input
and contact closure
DIP Switch to control input
sensitivity and bridging
4 x line inputs via XLR/TRS combo or
Euro-Phoenix connection
Amp Link
input
Movement sensor/contact closure for
Auto standby and 12VDC power output
Bosch Plena Matrix
PLENA MATRIX DSP MIXER
Multi-zone control centre for low-level mixing and routing of various sources.
Required to integrate call stations, control panels, ampliers, ethernet control.
Inputs include 4x mic/aux, 3x RCA, 1x Call station, Phoenix EVAC terminal.
Outputs to “Amp-link” RJ45 (x2) or (8x) 3-Pole Phoenix line level connectors.
8 ZONE CONTROLLER WITH 4 MIC & 3 BGM INPUTS + CALL STATION & CONTROL PANEL INPUTS
• Independent zone selection (up to 8 zones)
• Independent mixing of 4 x mic/line inputs (per zone)
• Independent 3 BGM source selection (per zone)
• Paging level control per zone. Ducking facility
• Input gain, HPF, PEQ (5 lters mic/line)
• Dynamic range compressor. Dynamic bass.
• Crossover (HPF, LPF, up to 8th order)
• Output PEQ (7 lters per output)
• Output delay (up to 120 ms)
• Output level control with phase inversion
• Call station, override and tones facility
Code
PLM-8M8
PLENA MATRIX DSP AMPLIFIERS
QUAD CHANNEL CLASS-D AMPLIFIERS WITH 4 LOCAL INPUTS
Can operate as a 4 zone amplier or bridge to operate as a single
zone high power stereo amplier. 4CH inputs accept line-level or
microphone, ¼” or XLR or hard wired connections, level trimming.
Sensor trigger inputs for auto stand-by power up/down. Use as part of
an expanded system or stand-alone with full featured IP control.
• Highly efcient Class D ampliers with low standby power
• Bridgeable outputs (1-2/3-4) for quad or stereo output
• Separate dedicated 4Ω / 8Ω / 70V / 100V on each output
• Level control of amplier output channels via IP controlled
• Built-in DSP feature set and full 4-channel mixer. Dynamic bass.
• Standby on/off (Auto Standby with optional motion detectors)
• Crossover Filters and EQ Filters (PEQ, HPF, LPF, Shelf)
• Delay control up to 120 ms delay per channel with distance
• Dynamic range compressor/limiting with advanced controls
• Local OVERRIDE connection for emergency, EVAC, etc.
Outputs Bridged Code
4x 125W 2x 250W PLM-4P125
4x 220W 2x 445W PLM-4P220
PLENA MATRIX CALL STATION
8 ZONE ANNOUNCING MICROPHONE
• Paging any combination of 8 zones
• Capacitive touch buttons
• Status LED indicators
• Label inserts printed from PC GUI
• Powered via CAT5 from PLM-8M8
• Daisy chained using CAT5 RJ45
Code
PLM-8CS
PLENA MATRIX WALL CONTROL PANEL
• Individual local zone controller
• Volume & input source selection
• Status LEDs & Volume level
• Label inserts printed from PC GUI
• Powered via CAT5 from PLM-8M8
• Daisy chain more units with CAT5
Code
PLM-WCP
Powered by CAT5 cable
from the PLM-8M8
Capacitive
touch buttons
Paper label inserts can
be printed off from GUI
CAT5 Cable
Power switch
and connector
Amp Link outputs 4 x Mic/ line input via
XLR/TRS combo
Line outputs
8x (-/c/+)
2x RJ45 (1-4+5-8)
Ethernet
control port
3 x BGM line
inputs via RCA
Call Station
connection
Balanced line input
for active override
Contact closures for activation of
emergency tones and override input
W
connection
IN-ZONE CONTROLLER
www.wescomponents.com/bosch
www.wescomponents.com/bosch
Comments to this Manuals